$425,000
Sternpicker 0155
{{ galleryProps.activeIndex + 1 }}/11
Condition:
Available Now
Hull Material:
Aluminum
Boat Builder:
Ed Wing
TYPE OF VESSEL: Triple jet powered gillnetter
SERVICE: Commercial fishing coastal waters of Bristol Bay, Alaska
DRYDOCKED: Lower Lummi, Naknek, AK, hauled at time of inspection
BUILDER: Ed Wing
YEAR: 1996
HULL CONSTRUCTION: Aluminum, hard chine, soft turn of bilge
Length - 32'
Beam…
TYPE OF VESSEL: Triple jet powered gillnetter
SERVICE: Commercial fishing coastal waters of Bristol Bay, Alaska
DRYDOCKED: Lower Lummi, Naknek, AK, hauled at time of inspection
BUILDER: Ed Wing
YEAR: 1996
HULL CONSTRUCTION: Aluminum, hard chine, soft turn of bilge
Length – 32′
Beam – 16″
Depth – 7.0′
Draft – 20”
Gross – 24T
Net – 19T
CABIN/GALLEY:
(4) berths, 4″ foam mattresses w/covers
Three burner Greystone Stove/oven
RCA 12v/110v R/F
Double s/s sink w/faucet
Large Formica table w/cushioned seats (seats 8); daybunk
Wallas 3000DX diesel cabin heater
BATHROOM:
Electric flush toilet
S/S sink, h/c faucets
Showerhead
Vent window
TOP HOUSE:
Aluminum construction w/360o window visibility
Aluminum eight-step access ladder
Berth
Double seating
Captain’s chair
(3) defrost fans
Three-step access to deck
ENGINE:
(2) Caterpillar 3116, 350 hp diesel
(1) Caterpillar C7.1 diesel
Tach: Port – 7845 Stb –7872 Center – 035
Center engine has direct drive
(2) Twin Disc 505A marine gear P/S
(2) Racor 1000 fuel filter, transparent lower drain, fuel shutoff Wet exhaust
Engine compartment vented to outside
TANKS:
Fuel – 400 gal. w/shutoff valve
Stove – propane tank
Fresh water – 60 gal.
Hot water – 6 gal. from engine waste heat
Propane on-demand for showers
Hydraulic – 35 gal. reservoir w/in-out lines, sight gauge
PUMPS:
1 ½” Jabsco overboard/washdown, lazarette and engine room
(2) Rule 2000 bilge w/float switch
(2) Cessna 321 hydraulic, driven by P/S engine
Par fresh water pressure pump
STEERING:
Two-station HydraFlex
Two-station UltraFlex frd/rev/throttles
ANCHOR GEAR:
Kinematic hydraulic anchor winch w/control lever and lock; P/S handrails
30kg 66# Claw anchor, secured with s/s wire
3/8″ iron lead chain
3/4″ Samson anchor line
Anchor bow roller guide
DECK GEAR:
Kinematic hydraulic roller w/high horns; Warn freeroll/locking hub
Aluminum narrow reel, hydraulic twist drive, White drum motor
(3) electric controls for reel, (1) hydraulic control
2 ½” aluminum ganion mast w/A-frame bracing; tow ring on mast
(2) 5” threaded aluminum wet deck drains
Mooring cleats
REFRIGERATION:
Integrated Marine Systems 8.5 ton RSW NEW 2021
Bosch compressor
Pacer 1 ½” s/s circulating pump
Jabsco 1” condenser
HATCHES/HOLDS:
Freeman 16″x26″ to lazarette
Escape hatch from fo’c’sle to foredeck
Large access, top of cabin, for engine removal
(6) large insulated fish holds, aluminum watertight covers w/non-skid
UNDERWATER FITTINGS:
(3) Kodiak 12” jet units, inter-cooled, exits thru exhaust
10” impellers
(3) 18”x30” grills
ELECTRICAL:
Marine wiring insulated, secured w/tie backs, breakers labeled
3500 watt 12/110v inverter
Hobbs work light under gunnels, stern
(2) Hobbs work light, on ganion bar mast
18” LED travel/docking light
O’head cabin lights
Navigation lights, 360o white anchor light, 360o red warning light
BATTERIES:
(3) 8-D, secured
Guest master selector switch
FIRE EXTINGUISHERS:
(3) 2 ½#, in the green
5#, in the green
ELECTRONICS:
Garmin GPS MAP 1042 XSV (mapping, transducer, radar)
Garmin GPS MAP 162
Garmin GPS MAP 421 S
Garmin GPS MAP 580S
Furuno GPS/WAAS navigator
Richie 4” magnetic compass w/night light
IPad w/bracket
LED 32” TV (galley)
PLACARDS:
Marpol
Oil Discharge
Zero Tolerance
Crew Injury
SAFETY FEATURES:
Life ring bearing vessel name w/60 ft. lifeline
(4) survival suits
Flare kit
First aid kit
Low oil pressure/engine o’heat audio/light warning system
Automatic bilge pumps
Fire extinguisher
Day shape
(2) heat sensor (engine room and @galley stove)
Co2 detector
P/S hand rail around anchor winch
Aqualarm for spray fuel propane
Co2 fire alarm
All deck surfaces non-skid
Pipe safety railings around deck and stern.
GENERAL DESCRIPTION AND CONDITION:
Vessel is of aluminum construction w/welded seams, square chine to a P/S 19” reverse chine full length, soft turn of bilge, semi-vee bottom to a square stern. There is a 3”x1” aluminum guard around the entire top of the hull; (3) 3”x2” rectangular stiffeners P/S mid-hull.
Anchor and anchor gear are on the forepeak, followed by the cabin with top house above. The fish holds and net reel are mid-ship, the Kodiak jet units sit on an aluminum box guard built over the jet units. The hydraulic roller is mounted in the stern on an aluminum frame to accommodate the flush deck. The Caterpillar engines sit under the stern deck. There is an enclosed aluminum
work deck with 1 ¼” hand rails.
Cabin interior has linoleum flooring, wood cabinets, Formica, vinyl, and aluminum; fo’c’sle has a foam- blown hard surface.
Top house is of aluminum construction and has a laminate ceiling, natural wood trim, soft foam walls, and linoleum flooring.
Vessel is equipped with good deck gear and electronics. There is an 18” fixed tab w/cut outs on transom to protect buckets.
This is a good work boat for the Bristol Bay fisheries.
IMPROVEMENTS:
2024
New impeller on jet units
New 8.5 ton IMS
New Caterpillar C-7.1
New fuel lines
New hydraulic lines and valves
New Garmin
2019
New RCA R/F
NOTES FROM THE SELLER:
FOR SALE is a full Bristol Bay Drift Net Operation. Boat is a 32 x 15.5 aluminum, triple jet, built by Ed Wing in 1996. Twin turbo CAT 3116’s each rated for 350 hp with wet exhaust. Center engine is a turbo CAT C7.1 rated to 425 hp that was installed in 2022 and also has wet exhaust. Twin Disc 505A marine gear on side engines and the center is direct drive. All three jet units are 12” Kodiak jets that are Hamilton clones. Boat drafts 20” and has a top speed of 29 knots and a cruising speed of around 23 knots. RSW is an IMS 8.5 ton hydraulic system installed in 2021. Packs 14 to 15 thousand lbs in 6 fish holds depending on amount of water that used. Each hold can be isolated and has 3 brailer bags per hold. Kinematic roller and narrow aluminum drum with a White Motor. 400 gallon single fuel tank and 60 gallon fresh water tank. Most fuel, hydraulic and freshwater lines have been recently replaced. Electronics include multiple Garmin units including a Garmin 1040s with mapping transducer and linked Garmin radar that was installed in 2022. Newer propane range and oven. 4 berths plus day bunk which 3 bunks have new mattresses. Spacious galley and head with new grinding toilet and a separate propane water heater if needed.
We are looking to sell the whole operation minus the permit but a permit is available to lease if needed.
Includes:
- 14 shackles of gear out of which 12 shackles are 50 fathom nets and 2 are 37.5.
- Sale will include a bunch of deck gear, tools and spare parts on board.
- It also comes with a locker full of extra parts such as alternators, starters, another White drum motor and a mostly complete extra CAT 3116 that ran when it was replaced.
- Also includes CAT C7.1 that could be rebuilt as a spare or used for spare parts.
- Finally, there is a 1987 Dodge Ram charger that runs.
This boat has put together profitable seasons every summer since it was built and WE have fished it collectively for 30+ seasons.
Price: $425,000
Sternpicker 0155
$425,000
Boat Builder:
Ed Wing
Propulsion:
Jet
Fuel Type:
Diesel
Length:
32 ft
Hull Material:
Aluminum
Special Notes:
Bristol Bay Gillnetter: 32' Ed Wing Aluminum Sternpicker, Triple Caterpillar Engines, Triple Kodiak 12" Jets. Packs 15,000 lbs. Salmon in 8.5 Ton IMS RSW in Flush Deck Fisholds. NEW IMS System, NEW Caterpillar C-7.1 Engine & More. Includes: 14 Shackles of Gear, Miscellaneous Deck Gear, Tools, Spare NEW Parts, Spare Used Engine Parts, 1987 Dodge Ram Charger Truck & More. Price: $425,000.
Contact Margaret Arvidson
Contact Margaret Arvidson for more information:
Contact Info:
- Broker: Margaret Arvidson
-
710 Third Street
P.O. Box 1722
Cordova, AK 99574 - Cell: 907.202.0012
- Local: 907.424.5335
- Email: info@crboats-permits.com
Copper River Boats & Permits LLC is acting as a broker and simply posting information provided to us by sellers. Our brokers have not inspected any of the items listed on the website. As such, we do not warrant the condition of any vessel, gear, equipment, or crew member listed on our site. All buyers must do their own due diligence and inspect the item being purchased. Buyer Beware. We provide no warranties express or implied.
Stay Up to Date!
Subscribe to our newsletter today!
Navigation:
Important Disclaimer: Copper River Boats & Permits LLC is acting as a broker and simply posting information provided to us by sellers. Our brokers have not inspected any of the items listed on the website. As such, we do not warrant the condition of any vessel, gear, equipment, or crew member listed on our site. All buyers must do their own due diligence and inspect the item being purchased. Buyer Beware. We provide no warranties express or implied.
Copyright (c) 2021. Copper River Boats & Permits, LLC. All Rights Reserved.
