$245,000
Bowpicker 0609
{{ galleryProps.activeIndex + 1 }}/25
Condition:
Available Now
Hull Material:
Aluminum
Boat Builder:
J & H Marine
TYPE OF VESSEL: Twin screw bowpicker gillnetter
SERVICE: Commercial fishing, coastal waters of Bristol Bay, Alaska
BUILDER: J & H Marine
YEAR: 1990
HULL CONSTRUCTION:
Welded aluminum
Length - 32’ snub-nose
Beam – 12’5”
Depth – 6’0”
…TYPE OF VESSEL: Twin screw bowpicker gillnetter
SERVICE: Commercial fishing, coastal waters of Bristol Bay, Alaska
BUILDER: J & H Marine
YEAR: 1990
HULL CONSTRUCTION:
Welded aluminum
Length – 32’ snub-nose
Beam – 12’5”
Depth – 6’0”
Draft – 34”
Gross – 16T
Net – 13T
DRYDOCKED: Lake Road, Dillingham, AK, hauled at time of survey
CABIN/GALLEY:
(2) bunks, 4” foam mattresses w/covers
Hillranger three-burner propane stove w/oven
12”x8”x8” s/s sink w/faucet(s), laminate counter top
Table/dinette seats (4), laminate table top; day bunk
Norcold R/F
Vinyl padded captain’s chair
Forced air Webasco heater, from engine waste heat
(3) fixed windows across forward cabin, window aft cabin, P/S sliders
American Bosch windshield wiper
Defrost fan plumbed from engine
Entry door w/window
FLYING BRIDGE:
Aluminum wraparound windguard
Aluminum five-step access ladder w/non-skid
Double-wide captain’s seat
ENGINE:
(2) Volvo Penta D6-330-AC, 330 hp ea, turbo after-cooled diesel
SN#2006033803 (port) SN#2006033798
Tach: Port – 07798 Starboard – 07817
(2) Racor 900FG fuel filter w/manifold and secondaries on engines
Wet exhaust
Engine compartment vented to outside
TANKS:
(2) 130 gal ea welded aluminum, sumps in engine room
Propane – (2) 2 gal aluminum, outside on aft cabin bulkhead
Potable water – (2) 20 gal plastic
Hot water – Atlantic 110v AC water heater
Lube oil – 7 gal aluminum, engine room
Hydraulic – 5 gal reservoir
40 gal w/sight gauge and shutoff valve (for RSW)
PUMPS:
1 ¼” Jabsco w/hydraulic power washdown and engine room pump out
Rule 2000 bilge w/float switch, engine room
Eaton 3.8 cu hydraulic
Vickers 13 gph hydraulic
STEERING:
Three-station Volvo
Three-station Volvo engine controls
ANCHOR GEAR:
Bruce 40# anchor, secured
½” iron lead chain
¾” rayon anchor line
DECK GEAR:
Aluminum bow roller
62”x22” aluminum, narrow width reel on adjustable slides, Kinematic
Twister drive
Aluminum free-standing mast
(2) 1”, (6) 5” x 1 ½” wet deck drains
(6) 8”x14” mooring cleats
Handrails
HATCHES/HOLDS:
Baier 26”x26” to RSW system
(6) fish holds w/non-skid sea hatch covers; 13,000# capacity
UNDERWATER FITTINGS:
(2) Volvo Penta outdrives w/spare
(2) counter-rotating Nybral props w/spare set
P/S trim tab
REFRIGERATION:
Integrated Marine System 8.5 ton, hydraulic driven off main engine
hydraulic pump
ELECTRICAL:
Marine wiring secured w/tie backs, breakers labeled at main helm
Hobbs work lights, P/S forward cabin
LED 16” docking light
(2) LED lights, forward bow roller
(2) LED lights P/S bow
O’head cabin lights
Navigation lights, 360o white anchor light, 360o red warning light
FIRE EXTINGUISHERS:
(2) 2# Kidde ABC, in the green, cabin entrance
Fire Boy 1301 automatic discharge, engine compartment
ELECTRONICS:
Bay Marine fathometer
Garmin plotter (touch)
Garmin GPS Map 840XS
Icom IC-2300H two-meter VHF radio
Standard Horizon Matrix AIS/GPS
T-U 20” TV screen
SAFETY FEATURES:
Life ring bearing vessel name w/tether
(3) survival suits
First aid kit
Flare kit
Automatic bilge pumps
Automatic discharge fire extinguisher
Low engine oil pressure
Co2/carbon monoxide detector
PLACARDS:
MARPOL
Oil discharge
Crew injury
Zero tolerance
Emergency Radio Procedure
GENERAL DESCRIPTION AND CONDITION:
Hull is of welded aluminum construction with welded seams. Bottom is ¼” and sides are 3/16”. There is a racked and bluff bow, planning bottom with slight vee, 7” reverse chine, square stern with a 2” aluminum pipe frame swim step. Framing is (2) ¼” x 4” x 12” and (2) ¼” x 5” x 6” engine bed stringers, (6) ¼” x 2” x 2” T stringers; 3/16” x 2” x 6” angle on 26” centers. There are (4) welded aluminum bulkheads. Decks are 3/16” aluminum plate; superstructure is 1/8” aluminum plate.
There is a 4” aluminum half-round around the entire top of the hull; (2) 3” aluminum half round stiffeners P/S midhull; 12” aluminum side rails with 1” aluminum tube around the work deck.
The snub-nose bow is a very nice custom feature
The hydraulic bow roller, which sits on an extended aluminum box to accommodate the flush deck, is on the forepeak; the aluminum salmon reel midhull, followed by the wheelhouse helm and accommodations on aft deck. At mid-stern there is an aluminum platform for protection of the outdrives.
Cabin interior has teak paneling and cabinets with teak trim, carpet/vinyl sole and laminate counter tops. All windows are mounted with metal frames; sliding windows are located P/S sides of cabin.
A voluntary dockside CG inspection #317309 is dated 2024.
Vessel is neat, clean and well cared for; well maintained, and a good work boat for its intended use.
RECENT IMPROVEMENTS:
2022
Depth sounder
VHF
Battery
(2) aft fish holds, aluminum void
2021
Enclosed work deck with 12” aluminum side rails, 1” aluminum tube
Newly reconditioned Twister drive on narrow width hydraulic reel
Flush deck
Sliding reel
Hydro lines; hydro valve bank
Safety rails
8.5 ton RSW
New bridge
Lower units reworked
All new braillers
Two-meter radio
2020
Depth sounder and VHF
Water heater
Battery
Bow sponsons
(3) frd fish holds sprayed foam insulated
Price: $245,000
Bowpicker 0609
$245,000
Boat Builder:
J & H Marine
Propulsion:
Outdrive
Fuel Type:
Diesel
Length:
32 ft
Hull Material:
Aluminum
Special Notes:
32' J & H Marine Twin Diesel Outdrive Bowpicker. Packs 13,000 lbs. in NEW 8.5 Tons IMS RSW. NEW Flush Decks, NEW Sliding Reel, NEW Bridge, NEW Safety Rails, NEW Electronics & More. Price: $245,000. Currently a Bristol Bay Bowpicker.
Contact Margaret Arvidson
Contact Margaret Arvidson for more information:
Contact Info:
- Broker: Margaret Arvidson
-
710 Third Street
P.O. Box 1722
Cordova, AK 99574 - Cell: 907.202.0012
- Local: 907.424.5335
- Email: info@crboats-permits.com
Copper River Boats & Permits LLC is acting as a broker and simply posting information provided to us by sellers. Our brokers have not inspected any of the items listed on the website. As such, we do not warrant the condition of any vessel, gear, equipment, or crew member listed on our site. All buyers must do their own due diligence and inspect the item being purchased. Buyer Beware. We provide no warranties express or implied.
Stay Up to Date!
Subscribe to our newsletter today!
Navigation:
Important Disclaimer: Copper River Boats & Permits LLC is acting as a broker and simply posting information provided to us by sellers. Our brokers have not inspected any of the items listed on the website. As such, we do not warrant the condition of any vessel, gear, equipment, or crew member listed on our site. All buyers must do their own due diligence and inspect the item being purchased. Buyer Beware. We provide no warranties express or implied.
Copyright (c) 2021. Copper River Boats & Permits, LLC. All Rights Reserved.
